Home
tech
The artist who turned his dead cat into a drone is now building a helicopter out of a cow

The artist who turned his dead cat into a drone is now building a helicopter out of a cow

It all started in 2012, when his cat Orville got hit by a car.

The artist who turned his dead cat into a drone is now building a helicopter out of a cow

Jansen decided it would be a shame to simply bury his late feline friend, so he drew inspiration from his pet's namesake — Orville Wright, one of the Wright Brothers, the inventors of heavier-than-air flight. Jansen gutted Orville, preserved him, and turned him into a custom quadcopter.

Jansen decided it would be a shame to simply bury his late feline friend, so he drew inspiration from his pet

The response was huge. Jansen had recruited the help of technical engineer Arjen Beltman to design and help fly his "half-cat, half-machine creation," and it was covered everywhere from Mail Online to Forbes.

The response was huge. Jansen had recruited the help of technical engineer Arjen Beltman to design and help fly his "half-cat, half-machine creation," and it was covered everywhere from Mail Online to Forbes.

According to the Los Angeles Times, the unconventional drone caused "global outrage" after footage of it went viral. The "Orvillecopter," as Jansen calls it, was subsequently exhibited as the Kunstrai art festival in Amsterdam.

According to the Los Angeles Times, the unconventional drone caused "global outrage" after footage of it went viral. The "Orvillecopter," as Jansen calls it, was subsequently exhibited as the Kunstrai art festival in Amsterdam.

After that success, Jansen got more ambitious. In 2013, his next project was again using a taxidermy animal as its base — but a far larger one. Jansen asked around local farms for a suitable animal, and one eventually got back to him with news of a recently deceased candidate: An ostrich.

After that success, Jansen got more ambitious. In 2013, his next project was again using a taxidermy animal as its base — but a far larger one. Jansen asked around local farms for a suitable animal, and one eventually got back to him with news of a recently deceased candidate: An ostrich.

Arjen Beltman again offered his services as engineer and pilot — "Without Arjen there are no flying animals," Jansen told me. "I build the puppet, he does all the electronics." RC Technics also gave financial support to the project, according to a Wired interview Jansen gave at the time.

Arjen Beltman again offered his services as engineer and pilot — "Without Arjen there are no flying animals," Jansen told me. "I build the puppet, he does all the electronics." RC Technics also gave financial support to the project, according to a Wired interview Jansen gave at the time.

Youtube Embed:
http://www.youtube.com/embed/HS-4s0ilxhs
Width: 800px
Height: 450px

Getting the shape done was the most difficult part," Jansen told Wired. "I looked at hundreds of pictures of live ostriches, dead ones, skinned ones to try and figure out what its body looked like. I had to then fit the skin around it and found that in some places I had too much foam and in others not enough. The skin then got a bit mildewy and I had to take it back to the taxidermist to treat it.

Getting the shape done was the most difficult part," Jansen told Wired. "I looked at hundreds of pictures of live ostriches, dead ones, skinned ones to try and figure out what its body looked like. I had to then fit the skin around it and found that in some places I had too much foam and in others not enough. The skin then got a bit mildewy and I had to take it back to the taxidermist to treat it.

Jansen and Beltman were at it again in 2014, giving a schoolboy's dead rat the Orville treatment.

Jansen and Beltman were at it again in 2014, giving a schoolboy

"When I learned he had cancer and the vet had to put him to sleep I was very upset," 13-year-old Pepeijn Bruins said of his pet "Ratjetoe." "I had seen Bart and Arjen and their flying cat, and I asked my dad if it would be possible to have the rat fly." Jansen was only too happy to oblige, transforming the deceased rodent into a remote-controlled flying machine.

"When I learned he had cancer and the vet had to put him to sleep I was very upset," 13-year-old Pepeijn Bruins said of his pet "Ratjetoe." "I had seen Bart and Arjen and their flying cat, and I asked my dad if it would be possible to have the rat fly." Jansen was only too happy to oblige, transforming the deceased rodent into a remote-controlled flying machine.

Youtube Embed:
http://www.youtube.com/embed/zKpVXYXFZhA
Width: 800px
Height: 450px

Jansen had another project in 2014 that saw less media attention than the others, but was no less impressive. He calls it the "sharkjet," and it's exactly what it sounds like.

Jansen had another project in 2014 that saw less media attention than the others, but was no less impressive. He calls it the "sharkjet," and it

Jansen managed to get his hands on a juvenile white tip reef shark from a local aquarium that had died of a bacterial infection, and the enterprising Dutchman strapped wings and a jet engine to the animal before sending it soaring through the air.

Jansen managed to get his hands on a juvenile white tip reef shark from a local aquarium that had died of a bacterial infection, and the enterprising Dutchman strapped wings and a jet engine to the animal before sending it soaring through the air.

Here's a video of it in action:

Here

Youtube Embed:
http://www.youtube.com/embed/qv9MFoIEe_g
Width: 800px
Height: 450px

When a friend offered him a dead badger, he immediately accepted, and soon settled on a use for it: a submarine. The project is called "Das Boot," a play on the famous German U-boat film "Das Boot," as well as the Dutch word for "badger" — "das."

When a friend offered him a dead badger, he immediately accepted, and soon settled on a use for it: a submarine. The project is called "Das Boot," a play on the famous German U-boat film "Das Boot," as well as the Dutch word for "badger" — "das."

Note: Bart Jansen's badger not pictured.

The project has run into some difficulties, however. He has struggled to find a lab willing to "plastinate" the badger skin — a preserving method he wants to use to waterproof it.

The project has run into some difficulties, however. He has struggled to find a lab willing to "plastinate" the badger skin — a preserving method he wants to use to waterproof it.

Plastination is the technique invented by anatomist Gunther von Hagens and famously shown off at the "Body Worlds" exhibition. This is a gorilla preserved using the method.

The skinned badger carcass has been sitting in his freezer for months.

The skinned badger carcass has been sitting in his freezer for months.

This carcass has been used to build a mould for the engine, and Jansen is now considering forgoing plastination altogether, due to fears about shrinkage.

This carcass has been used to build a mould for the engine, and Jansen is now considering forgoing plastination altogether, due to fears about shrinkage.

For the engine, Jansen and Beltman are building a jet propulsion system. " the propeller sucks up the water through a grid in the belly of the badger, and excretes it with force through the back end, which is a servo controlled pipe that can direct the jet stream left and right, up and down," Jansen tells me.

For the engine, Jansen and Beltman are building a jet propulsion system. " the propeller sucks up the water through a grid in the belly of the badger, and excretes it with force through the back end, which is a servo controlled pipe that can direct the jet stream left and right, up and down," Jansen tells me.

Because badgers are a protected species in the Netherlands, trying to develop a badger-skinned submarine is a more complex procedure than you might expect. You need to register at the police station, and authorities need to make sure that the badger wasn't killed deliberately, which would be an offence. Jansen won't be able to tour with the finished product either, as restrictions mean he'll be unlikely to be able to export it.

Because badgers are a protected species in the Netherlands, trying to develop a badger-skinned submarine is a more complex procedure than you might expect. You need to register at the police station, and authorities need to make sure that the badger wasn

The artist who turned his dead cat into a drone is now building a helicopter out of a cow

The artist who turned his dead cat into a drone is now building a helicopter out of a cow

Youtube Embed:
http://www.youtube.com/embed/8r2hYVA35_Q
Width: 800px
Height: 450px

Jansen views his projects as art. He and Beltman are trying to "invent a first machine for everything," he told me in January. "My work highlights situations that show the skewed balance between what we want to achieve and what we actually achieve, when pursuing that goal," his website explains.

Jansen views his projects as art. He and Beltman are trying to "invent a first machine for everything," he told me in January. "My work highlights situations that show the skewed balance between what we want to achieve and what we actually achieve, when pursuing that goal," his website explains.

Jansen doesn't just work with real dead animals. Here's one of his installation pieces, focusing on children's character Big Bird.

Jansen doesn

In 2007, the Netherlands was debating the burkha, a garment worn by Islamic women. "It was this blown up thing, for there were about 20 people in the whole bloody country wearing them," he says — so he decided to make a response.

In 2007, the Netherlands was debating the burkha, a garment worn by Islamic women. "It was this blown up thing, for there were about 20 people in the whole bloody country wearing them," he says — so he decided to make a response.

On the whole political mishmash about it I decided to reinvent the Burkha for all kinds of occasions. So that prohibition would not be necessary any longer.

On the whole political mishmash about it I decided to reinvent the Burkha for all kinds of occasions. So that prohibition would not be necessary any longer.

Burkha for everyone so to speak. There are a couple more, one with a bold clowns head and a twin burkha…for twins, or 2 girls, or 2 boys even. Hand in hand under the hood… everybody happy.

Burkha for everyone so to speak. There are a couple more, one with a bold clowns head and a twin burkha…for twins, or 2 girls, or 2 boys even. Hand in hand under the hood… everybody happy.

Here's another of his artworks — "The Last Dishes." He collaborated with Lars Reinboud on it, and it won the Summer Expo public prize at Gemeente Museum Den Haag in The Hague.

Here

Here's a recent video of Jansen's called "Pussy Destructor":

Here

Youtube Embed:
http://www.youtube.com/embed/vL3j1wsXIJ8
Width: 800px
Height: 450px

Jansen and Beltman have a new project: A "mancopter." He explains: "We’re still deciding on which shape our mancopter will have. Trying to build a flying motorcycle was one of the ideas, but that one is already been thought of by a different group of inventors. So we figured it be better to stick with what we know and build a one-person multicopter in the shape of an animal." What animal?

Jansen and Beltman have a new project: A "mancopter." He explains: "We’re still deciding on which shape our mancopter will have. Trying to build a flying motorcycle was one of the ideas, but that one is already been thought of by a different group of inventors. So we figured it be better to stick with what we know and build a one-person multicopter in the shape of an animal." What animal?

A cow could fit a person. So a cow is one of the options. That means we’d be using a cow indeed. Or any other animal we can lay our hands on that fits a person, but again, it’s in a very early state of development, all still in our minds.

A cow could fit a person. So a cow is one of the options. That means we’d be using a cow indeed. Or any other animal we can lay our hands on that fits a person, but again, it’s in a very early state of development, all still in our minds.

There's been huge media attention, but it has yet to translate into a commercial success story. A €100,000 offer for the Orvillecopter in 2012 never materialised. He told Business Insider he would be "happy to sell" the projects, but no one wants to buy them.

There

Another of Jansen's paintings.

We do TV shows, live shows and performances, that pay for the new projects," Jansen tells me. He also has a new plan for revenue up his sleeve: "We will start merchandising in a few weeks. People may not buy the Orvillecopter, but they might like a fridge magnet of it ...

We do TV shows, live shows and performances, that pay for the new projects," Jansen tells me. He also has a new plan for revenue up his sleeve: "We will start merchandising in a few weeks. People may not buy the Orvillecopter, but they might like a fridge magnet of it ...

View Other Slidelists

Advertisement